The UK's Finest Independent Forum for Shooters and Gun Owners. Est 2010.

I have a Musgrave rifle mounted in a laminated stock (not sure of exact make). The stock is starting to look a bit knocked about and has started soaking up water a bit on particularly wet range days. I'd like to re-varnish it to generally tidy it up and reseal it.

Is this something I could comfortably attempt myself or something that should be left to an expert?

What sort of varnish should be used and how should I go about preparing the stock?

Thanks,

Charlie.

That should help!

I had a laminated stocked TR that was looking a bit sad so I took to it with sandpaper and wire wool and lots of time!

I finished it with, I think, 5 coats of Tru Oil and the end result was very acceptable. Careful not to round sharp edges.

Good luck

JohnG :cornwall:

I have used laminated stocks for many years and they need to be completely sealed against water ingress or there is a risk that de-lamination may occur.

Therefore I don't think that traditional stock oil finishes are suitable. I would use a two-part clear cold cure lacquer such as Rustins Plastic Coating.

SD

I would be inclined to go with a two pack coating which will seal it fully but be warned, some such coatings do yellow with age.

Thanks for all the replies - that's certainly given me some avenues to look into. I'll try and get some decent pics of the stock later which might inform which method is most appropriate.