Page 1 of 1
Stainless bar stock
Posted: Tue Feb 17, 2015 10:54 pm
by Alpha1
I'm after a piece of stainless round bar stock about a 1-1/4" OD and about 4" long.
Re: Stainless bar stock
Posted: Tue Feb 17, 2015 11:21 pm
by Andy632
Alpha1 wrote:I'm after a piece of stainless round bar stock about a 1-1/4" OD and about 4" long.
Lots of it (303) but I'm in the Highlands.
Re: Stainless bar stock
Posted: Tue Feb 17, 2015 11:25 pm
by Alpha1
Hmm I think Ill ring a local steel stockists in the morning I think they sell 3m lengths. My guess is they will charge me a arm and a leg.
Re: Stainless bar stock
Posted: Tue Feb 17, 2015 11:34 pm
by ovenpaa
Would a length of stainless rifle barrel be of use? Just not sure if I have any as big as 32 mm as I tend to chop the chamber ends for sectioning
Re: Stainless bar stock
Posted: Tue Feb 17, 2015 11:40 pm
by Alpha1
I want it to make a 38/357 case holder for the LeWilson trimmer if the bore is small enough I could open it up. The OD of the Wilson case holders is 26mm.
Re: Stainless bar stock
Posted: Wed Feb 18, 2015 8:45 am
by Andy632
Alpha1 wrote:Hmm I think Ill ring a local steel stockists in the morning I think they sell 3m lengths. My guess is they will charge me a arm and a leg.
Check out any Marine workshops.
If stuck I can post you a bit, just need the postage.