Page 3 of 3
Re: Common Bolt faces
Posted: Thu Aug 16, 2012 5:14 pm
by dromia
OK I see, a wide variety of calibres is what you are after, however that is not what you wrote in your previous post. At least you knew what you meant even if you didn't write it.
Glad that you have made it clear now though, it will help the discussion.
Re: Common Bolt faces
Posted: Thu Aug 16, 2012 5:17 pm
by meles meles
We were rather expecting that you bigger brained creatures could process the information offered within the context of the discussion and come to the correct conclusion... :roll:
Re: Common Bolt faces
Posted: Thu Aug 16, 2012 8:22 pm
by dromia
Yet again you are wrong.
Re: Common Bolt faces
Posted: Fri Aug 17, 2012 8:54 pm
by meles meles
Aren't you oomans supposed to be the smartest kreechers on the planet ?
Re: Common Bolt faces
Posted: Fri Aug 17, 2012 9:54 pm
by ovenpaa
So long and thanks for all the fish...
Re: Common Bolt faces
Posted: Sat Aug 18, 2012 4:16 am
by dromia
meles meles wrote:Aren't you oomans supposed to be the smartest kreechers on the planet ?
That supposition shows that you aren't.
Re: Common Bolt faces
Posted: Sat Aug 18, 2012 12:31 pm
by meles meles
Quite so ooman. Maybe we should stop believing the propaganda the bald monkeys peddle...
Right, back now to the subject to paw (hand)
It would seem that we could have a common receiver that, by mixing barrels and bolts, could be used to fire a wide variety of different calibre bullets. The question then arises as to what would constitute a good receiver and bolt to start with, and how it should then be outfitted to complete the whole ensemble. Perhaps a Dolphin might be a good starting point ?
