Help! Bolt size for shooting table bolt
Moderator: dromia
Forum rules
Should your post be in Grumpy Old Men? This area is for general shooting related posts only please.
Should your post be in Grumpy Old Men? This area is for general shooting related posts only please.
-
phaedra1106
- Posts: 3429
- Joined: Wed Feb 08, 2012 9:37 pm
- Location: Just outside Sacriston (the nice bit!)
- Contact:
Re: Help! Bolt size for shooting table bolt
I don't have a bent bolt, the one shown circled is missing, it goes through a larger hole in the tubular arm (as shown) and the thread then screws into a bushing fitted into the table. The bit you can see sticking up behind the tube is one side of the wing nut fitted to the bolt, you use that to screw the bolt into the bushing. To replace the bushing I'd have to strip off the top padded cover.
There's room for all Gods creatures, next to the mash and gravy :)
-
phaedra1106
- Posts: 3429
- Joined: Wed Feb 08, 2012 9:37 pm
- Location: Just outside Sacriston (the nice bit!)
- Contact:
Re: Help! Bolt size for shooting table bolt
Edited.
Forget all that, I've got access to an M8 tap so going to re-thread the inserts so my M8 bolt fits.
Forget all that, I've got access to an M8 tap so going to re-thread the inserts so my M8 bolt fits.
There's room for all Gods creatures, next to the mash and gravy :)
Who is online
Users browsing this forum: No registered users and 6 guests