Page 2 of 2
Re: Wamadet reloading press spares.
Posted: Fri Mar 31, 2017 6:32 am
by dromia
Sounds more like climbing up the wrong arses.
Re: Wamadet reloading press spares.
Posted: Thu Jun 01, 2017 10:49 am
by nunhead
Back to talking about the WAMADET!
I have a box of Os & Ss which are up in the attic.
Re: Wamadet reloading press spares.
Posted: Thu Jun 01, 2017 2:53 pm
by Alpha1
The Wamadet is all sorted now. Thanks for the offer.
And as for the machinery I didn't do to bad I managed to acquire a Myford ML10 thats only been used for screw cutting for free. Its fully tooled as well. I also got some other stuff but i wont bore you with the details. My current work shop is getting very crowded.
The Wamadet gets used a lot its a cracking press.
Re: Wamadet reloading press spares.
Posted: Fri Jun 02, 2017 6:56 am
by ovenpaa
From memory Myford eventually produced an all metric ML10, is yours the one with the taper roller bearings or the plain bearings?
Re: Wamadet reloading press spares.
Posted: Fri Jun 02, 2017 1:36 pm
by Alpha1
Not sure its an early model but its had very little use I think its imperial. I have not had chance to check it out. Its sat under a bench at the moment with a blanket over it. I don't have any room in my work shop to set it up I have ran out of space. I'm still tinkering with the other lathe I put it on a larger Bench. I ditched all the Chinese electrics and fitted a new motor an inverter and a new speed control unit. I am in the process of fitting power feeds to it at the moment. The difference with the new set up is amazing. Next job is fitting a 3 axis Digital Read out to the Mill. Then a bigger work shop I hope to house it all.